Non Slip Mono Loop Knot

To tie a Non Slip Mono Loop Knot follow these steps:

1. Make an overhand knot in the end tag but do not tighten. Before inserting the end through the hook eye.

2. Bring the end back through the overhand loop make sure it enters from the same side it exited and wrap it several times around the standing line.

3. Bring the tag back through the overhand knot again making sure it enters from the same side it exited .

4. Lubticate and tighten by pulling on the bend of the hook with one hand and the standing line with the other, making small adjustments to control the size of the final loop. Trim Tag.

Non Slip Mono Loop Knot Photo: